it can be converted into an almost pure carbon material at higher temperatures. Fiberglass chopped strand mat sample cured in an oven at 250 &Indoor type polyester resin Manufacturers 8451;.MG resin combine with fiber reinforcement using conventional processing technology to provide for low-cost, high-temperature structural composites potential..
Although the polymer formulation, processing and curing cycle to continue to decrease further optimized porosity, overall, the resulting composite exhibits good. Water is the only volatile generation thing, it does need to be managed porosity, polymer analogous condensation reaction, such as phenolic resins and polyimides.MG1000 test sample produced by glass fiber and carbon fiber fabrics and carbon fiber mat and hand lay-up by vacuum injection. Breadboard use abrasive fibers and resin production, and strive to explore low-density material ablation and thermal protection systems for (TPS) for the potential use spacecraft.
MG3000 test sample was prepared in a similar manner. In addition, it can be curable into a thermoplastic state at temperatures below 110 ℃, when the temperature is higher than 110 ℃ it will crosslinking. Carbon fiber panels and carbon mat plate is autoclave at 200-250 ℃ and 2 hours post-curing.The new high temperature resinPosted by zccyfiberglass on December 25th, 2015CRG company has developed a new high temperature resin (service temperature is 300-450 ℃) with ultra-low flammability, heat release and smoke release, similar to the workability and cost of epoxy resin. However, preliminary tests MG resin composites showed lower amplitude compared to the heat # release phenolic resin
Although the polymer formulation, processing and curing cycle to continue to decrease further optimized porosity, overall, the resulting composite exhibits good. Water is the only volatile generation thing, it does need to be managed porosity, polymer analogous condensation reaction, such as phenolic resins and polyimides.MG1000 test sample produced by glass fiber and carbon fiber fabrics and carbon fiber mat and hand lay-up by vacuum injection. Breadboard use abrasive fibers and resin production, and strive to explore low-density material ablation and thermal protection systems for (TPS) for the potential use spacecraft.
MG3000 test sample was prepared in a similar manner. In addition, it can be curable into a thermoplastic state at temperatures below 110 ℃, when the temperature is higher than 110 ℃ it will crosslinking. Carbon fiber panels and carbon mat plate is autoclave at 200-250 ℃ and 2 hours post-curing.The new high temperature resinPosted by zccyfiberglass on December 25th, 2015CRG company has developed a new high temperature resin (service temperature is 300-450 ℃) with ultra-low flammability, heat release and smoke release, similar to the workability and cost of epoxy resin. However, preliminary tests MG resin composites showed lower amplitude compared to the heat # release phenolic resin
コメント